Advantages of Urecon's insulated duct system: Very lightweight (approximately 4.5 kg (10 lbs) per length). Incorporates Urecon's eco-friendly U.I.P. polyurethane foam, which is the best insulation available in the market today; refer to the product submittal data sheet or specifications for more details. UV stable polyethylene jacket is both tough and waterproof over the long term; this is critical for maintaining maximum efficiency of insulation. Flimsy thin jackets usually don't stand up to the wear and tear of transport, let alone long term underground performance. Wet or damp insulation of any type simply does not work. The insulation has a constant diameter down the entire pipe, including over the bell end. The insulation and jacket are factory trimmed flush with the bell end, allowing the insulation to butt up against itself as the pipes and / or fittings are being solvent welded and pushed together. Butyl mastic sealant tape is supplied for all pipe and fitting ends to seal the system against water ingress, 45 and 90 degree solvent weld PVC short or long sweep factory insulated elbows are available for building entries and changes of direction.

An insulated duct system gives you the flexibility to use whatever core pipe you think is best
suited for your application, preferably pulled through the duct in continuous runs with no unions.

The duct also allows you to run other utilities in the same raceway (local codes
and bylaws permitting) i.e. telephone, cable, high speed internet, power, etc.

Once the Urecon insulated duct system is installed, two runs of the supply and return core
pipe of choice (locally supplied by others) are pulled through to complete the installation.